6091

[aznepydna]

Can a Stream be controlled with the 6091 controller?

 

[rvitko]

Yes, it is not the most effective way to use a Stream but it will work.

 

[aznepydna]

I was thinking of using the slave section along with my wavebox.

 

[rvitko]

It will work and may slightly boost wave height depending on how big the tank is. It may be more useful though on a slower pulse (7091 or 7095 or 7096) where it would create more flow in total.

 

[Jar*Head]

You will not have much of the directional flow by using it with the 6091 controller.

 

[aznepydna]

I was going to mount the stream opposite the nano wavebox to try and increase wave height. There is a youtube video of a stream on a homemade controller that makes one heck of a wave. I was hoping that I can do the same by using a stream on the slave output of the 6091.

 

[Jar*Head]

Make sure you change the jumper inside the controller if you decided to place the stream on the opposite side. If you place the stream on the same side as the wavebox then you don't have to change anything.

 

[Jar*Head]

If you decided to change the jumper here is how to do it:

1. use flat head screw driver to remove the white dialing knob. It will pop out without using much effort.

2. Remove the screws in the back of the controller. The cover will open as soon as you loose the screws.

3. There is 3 setting inside the controller. Sync, ...., and External. You should use the one in the middle . God forbit i forgot the name lol

By changing the jumber both pump and wavebox will not run the same time. If you don't change the jumber, the stream and wavebox will cancelling each other out....