6100 connector?

[gmatt]

I have a question. I want to build my overflow around the Tunze 6100's. I would like to put bulkheads in my overflow to run the cables for the 6100's out of the tank. The overflow is calfo type at top of the tank running full left to right. The 6100's will be under the overflow box. I would like to run the cables from under the overflow through the bulkhead then out of the overflow and tank.

My question is how big is the plug on the tunze 6100?
Assuming it disconnects from the other parts (the transformer and the other box). In short what's the smallest size bulkhead I can put in the overflow to allow the tunze pump plug through? Can I use a 1/2in. bulkhead?

Sorry, second question, are two 6100 Tunze enough for a 4'x2'x2' 120 gallon, that is SPS dominant with some fish? Other pumps 1200 gph sump return.

Tanks in advance for any help,

Gmatt

 

[rvitko]

2 6100's may well be to much unless it is pretty much exclusivel SPS and bare bottom. It is a 6pin Molex connecter, I believe it is about 1/2" but I would probably go 3/4" to be on the safe side.

 

[gmatt]

<a href=showthread.php?s=&postid=7272303#post7272303 target=_blank>Originally posted</a> by rvitko
2 6100's may well be to much unless it is pretty much exclusivel SPS and bare bottom. It is a 6pin Molex connecter, I believe it is about 1/2" but I would probably go 3/4" to be on the safe side.

What about using two 6000's would that be enough for primarily SPS and some fish, with a small shallow ammount of coarse gravel, in a 120 gal.?

So the pump has a cable with with a 6 pin Molex connector, which plugs into the Driver, then the driver uses another cable to plug into the Doughnut transformer, then the transformer plugs into the Controller?

 

[goth]

The controller also plugs in the driver. The transformer plugs into the wall (and it also power the controller).

-yvest