6101 Power end a very poor fit

[sjames]

Howdy,

I have a pair of 6101s, on one of them the power cord is a very loose fit into the block at the end of the 6101 cord. You can feel no resistance when plugging it in and its very susceptable to getting easly unplugged or losing contact.

Anyone have an easy fix for this? I though about crimping the end a hair, but was not sure if that was a wise move.

 

[rvitko]

That is a difficult call, I think you could crimp it but the best repair would probably be if we replaced it. Do you think you could get by until I returned from Germany? I will be back in early June and we can work out a replacement of the socket.

 

[sjames]

Roger,

Thanks, yes its fine untill then, it generally does not cause problems, Its just every so often Ill notice the pump isnt running.

Thanks for your attention on this.

Sam