6101's & 7095...

[drewid]

hi,
i have 2x 6101 turbelles running off a 7095 controller, they were running fine over the last year but today i noticed one wasnt working..

i have cleaning and interchanging the impellers, disconnecting the supply for about 10mins, but nothing..

i disconnected the 7095 and reset both pumps and found them to work fine individually, but once i reconnect it to the 7095 one pump it works for once cycle and then does not start again.. the other one on channel 1 works fine.. if i connect both on the same channel only the one pump works (same as before).. if i connect the presumed faulty pump by itself on the 7095 it does not work..

is it the controller which is not working correctly or the turbelle? if so what options are there??

Thanks,
Dennis..

 

[rvitko]

Most likely it is the pump or the controller cable. If it is less than 2 years old, your dealer should be able to replace it under warranty so long as the connector didn't get wet.