6105 Control Power question

[Mark Bianco]

Roger, / Tech Support,

My pumps will be here Friday. :celeb3: I have read in several places the it is not reccomended to run the pumps at below 30%. Since the power supply is capable via the jumper of either 12, 18, or 24v does this hold true for all of the voltage setting or only the lowest setting?

Thanks in advance
Mark

 

[rvitko]

This holds true for all voltages. The power supply voltage is a bit independent of the controllers functions, the controller must always get 8V and so long as the power supply is putting out at least 10 this should be fine. If the potentiometer on the pump is turned down and a controller used or a controller is turned down too far, this will impair the signal to and from the controller and this is where the problem is.