I am having an issue with one of my 6105 pumps. 1 power supply will not run either pump and the light is on solid unconnected and flashes when connected. The other supply will run 1 pump only. On the pump that does not run, the metal shaft comes out with the impeller. From what I've read, I feel I need to order a new power supply, but on the pump that does not work do I need a new impeller or do I need to send the pump in? Thank you, Kurt.
6105 problem
- Thread starter klm2500hd
- Start date
It depends on the age of the pump, if the pump was made before Nov 2011, the shaft was removable, it has a blue bushing on either end and the shaft reaches to a socket in the front propeller cover. If it is newer, the shaft should be fixed in the motor and it should be sent in.
I would make sure both pumps are clean. The power supplies would normally flash if the draw is over 50W, if one power supply has an 18V jumper and a 24V jumper that could be the difference or the pumps may be dirty and draw 48W for example and one is just a little more sensitive. If the pumps are clean at 24V they need about 30W.
I would make sure both pumps are clean. The power supplies would normally flash if the draw is over 50W, if one power supply has an 18V jumper and a 24V jumper that could be the difference or the pumps may be dirty and draw 48W for example and one is just a little more sensitive. If the pumps are clean at 24V they need about 30W.
Similar threads
