6105?

[franklinbeens]

hello roger are you replacing 6101 blocks with 6105 working pumps?
i sent a 6101 block for repair & you sent me a 6105
back. the 18v fuse you sent with it doesn't work for me but my 24v does. btw how do you keep the pump from rotating due to motor
torque? the clamp that came with it works with the older magnet
holder.
thanks

 

[rvitko]

If the clamp is loose on the pump, just squeeze it in and it will tighten up, some of suggested using hot water to soften it, but I don't believe that is necessary.

6101 motors are no longer made, the 6105 is the replacement. Are you sure the 18V jumper is plugged in right? It is possible to miss the contacts when you slide it in.

 

[franklinbeens]

15v & 24v works but the 18v does not. the red light works with it though.
can't i use the 24v or 15v?
thanks

 

[rvitko]

15V would be OK for the time being, PM me your name and I will send a new 18V jumper.

 

[franklinbeens]

never mind, on closer inspection my pins was bend down a bit so i bent them back and all is well.
i was using the 24v for less than 10 minutes.
thanks again