7094 Multi-Controller Program Question

[Maveri9720]

Roger,

Hi Roger, I recently bought a used 7094 for my 2 6000's in my 120g mixed tank. I have one pump on each side and had the controller set on the top mode on the mode switch. One pump was dialed in to 50% on Ch A and 30% on Ch B and the other pump was the opposite of that, with the max pulse (5 sec) in between.

This is what I want to do, except I want to extend the time to like a few minutes or so. But when I tried the middle mode on the mode switch, it shut off the pump completely, which I don't want.

Is there any config that will allow me to run one pump at a certain %, couple minutes pass, then reduce that pump and kick on the other pump at a certain %, then reduce that pump and kick on the other?

I don't want one pump shutting off completely.

Thanks for the help. The manual was pretty confusing to me, so I thought I would ask.

 

[rvitko]

It isn't possible on the 7094, there is a program close to that on the 7095, Interval 2, it lets you idle one pump while the other pulses but that is the closest to that. The pulses are fast because the idea is for the slow and fast moving water to collide and spread so that it creates more turbulence.