7095 moonlight dead :(

[MFR]

The moonlight is not working. Possibly wet? Can I replace it? Will this affect "night mode"- I assume it will?

Also, while I am at it. I am running two 6000s in a 48 X 20 X 20 ",, mostly SPS w/ about 1" of sand. Can you recommend a setting on the controller?

Best,

MFR

 

[rvitko]

I can repair it, some of the first ones weren't sealed sufficently and water shorted the light. It would have to be sent in as the light is soldered in.

If you can, use Interval 2 at 6 hr intervals. This is best because the pump service life between cleanings is longest.

 

[MFR]

cool!

cool!

I will send it in tomorrow. Can I have your adress?

I have the pumps on interval 2, 3-4 sec. pulse. The 6 hr. interval threw me off. It seems like a long time before it switches over but, in reading other posts I see that is the recommendation (tidal flow). Finally, should I just crank the pumps down to 50% while the 7095 is being serviced?

Best,

MFR

 

[rvitko]

It won't take long to repair.

Tunze USA
1304 Monica St
Austin TX 78758

I think the setting at 50% is fine.