7095

[bayoupr]

Brand new 7095 and I can't get the night mode to work. Does this need to be calibrated like the 7090 controllers I have hooked to the 7095? I cover the photocell completely in a black cloth and the pumps keep running like normal, moon light comes on.

 

[rvitko]

It may be a misunderstanding of what it is supposed to do? What should happen on a 7095 is the pumps stop pulsing and run at whatever the Speed 2 knobs are set to for each channel. If the moonlight comes on it should be active and the calibration is only to set the minimum speed so they don't stall. If it isn't working, I would double check that the 7090's are set to external.

 

[bayoupr]

The 7090's are on external, my low speed is set at 30% but the program continues to run like normal. On the 7090's what setting should the three knobs be set at when running on external?

 

[rvitko]

Is the 30% the bottom most knobs though? It goes to whatever the knobs on the bottom of the controller are set to, Speed 2. In External the only knob that matters is main power and it should be 100%.

 

[bayoupr]

Bottom knob 30% on which controller, 7095 or 7090? 7090 is at 100% external mode, 7095 is set at, upper min/max 30%, bottom min/max knob 90%.

 

[rvitko]

On the 7095, as it is set up now, night mode is 90% with no pulsing, you need to reverse that for night mode to be 30%.

 

[bayoupr]

That might work. I had the buttons mixed up thinking the top button was min power and the bottom button max power.