7097 with 6040 (not working)

[naamah75]

Hi! I already have a 7097 multicontroller with two LED 8850 and all work fine.
Now I bought two Turbelle 6040; connected to the 7097 and... the pumps are not working! (obviously I selected the "external control" mode ).
The LEDs on the 7079 show me that the config is right on the controller; so the "interval mode" is ON and the pulse and ramp timing is correct; but the pumps still not works.
I've tried to set the two pumps working togheter using only the 6040 controller (detached from the 7097) one as master and the other controller as slave, in this mode all works good (also the inverse mode).
How I'm wrong?

 

[naamah75]

This is my configuration of the controller...

 

[naamah75]

 

[naamah75]

 

[rvitko]

Are you sure no light setting are made for sockets 2 and 4 as well?

 

[naamah75]

I discovered on a German forum that there is a small bug in the Tunze software; so that to the channel where the pumps are connected need to
set the time field in the "socket outlet switch panel" from 12:00
to 12:01.
I did this all works correctly.

 

[rvitko]

OK, I did not know this, but thank you!