About Tide Mode

[7thheaven]

Hi~

I have two 6100s and Multicontroller.
I searched every post about word "Tide"
and The Point of Tide mode may be this

I would place them on the back corner aimed to the front one third of the way in from the side they are mounted on. Use tide mode so only one runs at a time.

and I have more question about tide mode.

When I use "Tide Mode", Can I make both pump are working?

I mean, in tide moe, just only one runs at a time. so....
what The two flow of opposite direction meet is important I think...

Can I program this?

one pump runs and make water flow--> the other pump runs
and make water flow -> both pumps run and make water flow.

sorry for bad English..

Thanks in advance.

 

[rvitko]

No, this isn't possible. You could use pulse mode which would run both pumps and you could set the pulse speeds independently. On the 7095 their is a new mode which idles one pump at 30% and pulses the other.