Y Yossia New member Oct 16, 2005 #1 1. Am I correct to assume that there are 2 input pins and program should refer to them as "Switch1" and "Switch2" ? 2. Is it correct that to set each input to ON I need to short it to the ground (common) pin? 3. How do I buy a Minidin to open end cable?
1. Am I correct to assume that there are 2 input pins and program should refer to them as "Switch1" and "Switch2" ? 2. Is it correct that to set each input to ON I need to short it to the ground (common) pin? 3. How do I buy a Minidin to open end cable?
K kattner New member Oct 17, 2005 #2 There are 4 inputs. See this thread for help on how to do it: http://www.reefcentral.com/forums/showthread.php?threadid=645837 Ken
There are 4 inputs. See this thread for help on how to do it: http://www.reefcentral.com/forums/showthread.php?threadid=645837 Ken
Y Yossia New member Oct 17, 2005 #3 Ken, Thanks. Mine is AC Pro and not ACIII. I looked at ACIII manual and there are indeed 4 inputs. Not so in the AC Pro according to the manual. Also nowhere in the AC Pro manual no tokens like Switch1 and Switch2 are mentioned but only Switch. So I am a bit confused.
Ken, Thanks. Mine is AC Pro and not ACIII. I looked at ACIII manual and there are indeed 4 inputs. Not so in the AC Pro according to the manual. Also nowhere in the AC Pro manual no tokens like Switch1 and Switch2 are mentioned but only Switch. So I am a bit confused.
C clp .Registered Member Oct 17, 2005 #4 Yossia, The switches are referred to as Switch1 and Switch2 in the ACPRO. The switch input is "Closed" when shorted to the ground pin. For example: If Switch1 Closed Then FOO ON If Switch1 Open Then FOO OFF would turn on FOO when switch1 is connected to the ground pin. You'll have to order the I/O cable directly from us (408-578-3022). The part number is MINIDIN8CABLE and the cost is $15. Curt
Yossia, The switches are referred to as Switch1 and Switch2 in the ACPRO. The switch input is "Closed" when shorted to the ground pin. For example: If Switch1 Closed Then FOO ON If Switch1 Open Then FOO OFF would turn on FOO when switch1 is connected to the ground pin. You'll have to order the I/O cable directly from us (408-578-3022). The part number is MINIDIN8CABLE and the cost is $15. Curt
