cantonreef
New member
Is this a repairable part? I have a 6105 and the adjusting screw has broken off. Can this be replaced? Can the entire part that the adjusting screw is a part of, be replaced?
Adjusting screw on 6105
- Thread starter cantonreef
- Start date
The knob is fairly easy to replace, you will use a small phillips screwdriver to pop out the remnants of the old one and install the new knob, for that matter you can just use a phillips screwdriver to make adjustments as well. Keep in mind though that this adjustment is only to be used when no controller will be used. It must be always at 100% when a controller is being used.
The entire end connector can be replaced but this is a more complicated repair as the old one must be unsoldered and the new one soldered in after the wires are cut back and repaired as needed.
The entire end connector can be replaced but this is a more complicated repair as the old one must be unsoldered and the new one soldered in after the wires are cut back and repaired as needed.
