Alarm Module?

[drillsar]

Can this be used for the Alarm module?

http://www.asihome.com/ASIshop/product_info.php?products_id=654

Apparently the CM506 has been discontinued

 

[preef]

I'm not sure what you are trying to do. I bought one of these Sonalerts. http://www.mouser.com/search/ProductDetail.aspx?R=539-PS523AQ It looks nothing like the picture on the web page. Refer to the pdf.

It runs from 12 volts so I wired it to a small 12V power supply I had from an old router. You can buy the power supplies from Radio Shack too. I plugged it into one of the relay outlets on an EB8.

It is freaking loud. My Apex will turn it on in response to my Waterbug detecting wet carpet.

 

[zero26]

I was wondering the same thing too. I have a old X10 alarm module, how could I wire it? With maybe a breakout box?


http://www.homesecuritystore.com/p-770-psh02-x10-power-horn-105db-siren.aspx?affiliateid=10050&zmam=55691497&zmas=1&zmac=2&zmap=PSH02

 

[swearint]

It looks like the siren module accepts an RJ11 cable. Hook it up to the control port on the Apex, and create a legacy outlet with the matching address. Then you could program it as needed to turn ON/OFF.

Todd

 

[jduck]

I went to radio shack and picked up a couple diffrent buzzers/ alarms. The shrill one for if there is any water detected, temp, ph, salinity change, buzz for full skimmer, or low sump level. But in addition I have all if them setup for email/texting alarms also