Apex firmware beta 4.20_BF12

The only difference I see is that when editing the dashboard, clicking on a tilelink no longer takes you to the outlet edit page. But then I don't know if that is new, since I didn't test that on BE12, and not sure what else they tried to fix.

The power bugs still are present.

Otherwise, everything so far has been good with this version.
 
I used my neighbors laptop and updated to BF12. The AI SOL lightening feature still does not work, and it seems that the Storms light dimming feature broke it did work before, just not the lightening. I'll reboot the controller and see if that makes a difference.
 
Just updated firmware. Display shows update was successful: rev 4.20L - BF12. However, the web interface looks the same. I have cleared cache, etc. what am i doing wrong?
 
Don't think there was any visual updates, I think it was all performance. However, there is no changelog to go off of.
 
The dashboard reseting to default when ? character still happening. I was hoping this would work. I'm sure it will get fixed sooner or later.
 
Issue I had with install of 4.20_BF12.

Successfully updated the controller firmware but it was failing on updating the web pages. Cleared the browser caches as per the instructions but it continually returned the error 413.

I was able to successfully complete the web install, by running it about 15 times, each time it would process one or more files until it finally installed. Seems it is timing out or something. I am using Win 8 with Chrome 23.0.1271.64m

Decided to try again and booted to Windows safe mode with networking and it installed without a hitch.
 
Is there a way of restoring the season table without initializing the whole system. Would like to see the option of restoring to the default.
 
i have a Float Switch to let me know when i need to put water in my ato bucket if i forget to top it off.i get a email telling me switch 3 is open so i top off the bucket but i keep getting emails to i delete it from EmailAlm and put it back in EmailAlm. i can see the switch go from open to close.this is what i put in to get it to email me is this right?
If Switch3 OPEN Then ON
If Switch3 Closed Then OFF
 
this is what i put in to get it to email me is this right?
lowscooby, this thread is intended for feedback about the current beta firmware. Your question is a general usage/programming question. Please start a new thread - and in that thread, post your full email outlet program.
 
Any changes to the webpages or just the firmware? :)

The key issues I am aware of being fixed includes:

IE 10 fixed

VDM configuration works

Other (nonspecific bugs)

You should always update both firmware and webpages.
 
Back
Top