Aquaforest
.Registered Member
Last edited:
Aquaforest products- Component 1+2+3+
- Thread starter Aquaforest
- Start date
MichaelW
New member
I have just a few questions about this balling type system
1. Some Alk and calcium supplements I have used in the past are balanced (same dose requires of each) where some I dose a lot more alk than Calcium. Currently I dose way more alkalinity supplement than Calcium to keep my parameters stable. Does you supplements tend to need about the same dosage of each?
2. Your mag supplement is part of the calcium supplement.right now i do not need to dose magnesium as it seems to be kept in line with water changes and doesn't deplete in my system. Wouldn't it having to be dosed with calcium keep raising my mg way higher than I want?
3. The component 3 is mineral salts. How do we know how much to dose. It is not like all where we test consumption. Do you just dose the same as the amounts you dose for the other components? This must assume both alk and calcium demand the same volume of dosing)
I have stayed using many of your other products and really like the results so I was thinking of swithching from fauna marin balling lite to your system but just had these questions. Thanks for any response.
1. Some Alk and calcium supplements I have used in the past are balanced (same dose requires of each) where some I dose a lot more alk than Calcium. Currently I dose way more alkalinity supplement than Calcium to keep my parameters stable. Does you supplements tend to need about the same dosage of each?
2. Your mag supplement is part of the calcium supplement.right now i do not need to dose magnesium as it seems to be kept in line with water changes and doesn't deplete in my system. Wouldn't it having to be dosed with calcium keep raising my mg way higher than I want?
3. The component 3 is mineral salts. How do we know how much to dose. It is not like all where we test consumption. Do you just dose the same as the amounts you dose for the other components? This must assume both alk and calcium demand the same volume of dosing)
I have stayed using many of your other products and really like the results so I was thinking of swithching from fauna marin balling lite to your system but just had these questions. Thanks for any response.
Aquaforest
.Registered Member
Hello,
Thank You for Your questions.
We recommend to dose every Components in the same dose.
For example:
Component 1+ - 100ml
Component 2+ - 100ml
Component 3+ - 100ml
If some macroelement is lower than optimum water parameters You Can use Calcium, Magnesium or Kh Buffer separate.
Component1+2+3+ contains microelements also so we do not recommend to use that to rise for example Ca only - because microelements will also rise.
Component 3+ contains Reef Mineral Salt and We recommend to use that in the same dose like every Components.
Can You tell us how much You dosing Balling method and what is Your water parameters?
Regards,
Aquaforest
MichaelW
New member
Right now I use the fauna marin balling lite method which also uses trace elements in containers but the 3 containers. Alk, calcium, mag. No container for mineral salts.
I dose ;
Alk 210 ml per day
Calcium 70 ml per day
Mag 0 ml per day
As you can tell very different amounts.
This dosing keeps my params as;
Alk 7.1
Ca 410
Mg 1350
paal
New member
Hello,
I will start a new tank shortly, and have planned to run your products from day one.
I have not used Aquaforest Comp 1/2/3 before, so I do not know if this will be an issue, but when I used to run balling light on my previous tank, I had to dose slightly different amounts from the three canisters because Mg/Alk/Ca had small "unbalances".
Maybe Aquaforest Comp 1/2/3 will give me great values with identical dosings, but for now, let us assume it will not and I therefore will have to add additional Calcium, Magnesium or Kh Buffer like described above.
I currently only have a 3-channel dosing pump, and I do not want to dose manually. Would I have to buy new dosing pumps for pure Calcium, Magnesium and Kh Buffer, or could I just add some of this to the corresponding Aquaforest Comp 1/2/3 canisters to "spike them up" if values are not perfect?
Hopefully that made sense
MichaelW
New member
Is there any response to this? I have nearly used all my current balling mixtures and wanted to go with AF balling system but right now I don't add Magnesium, and didn't want to raise my mag when dosing ca.not sure why my mag sits at 1400 with no dosing... Salt mix isn't supposed to be that high.
Tweaked
FUP&A Member
If it were me I would have two options.
Start the Components 1,2, and 3 and watch and observe levels over the next couple weeks.
or
Start 2, and 3, and manually dose Calcium while Mg dropped. Note: you would be missing Sr, Ba, Co, Mn, Cu, Fe, Zn, Ni, Cr components that normally come with dosing Part 1.
Start the Components 1,2, and 3 and watch and observe levels over the next couple weeks.
or
Start 2, and 3, and manually dose Calcium while Mg dropped. Note: you would be missing Sr, Ba, Co, Mn, Cu, Fe, Zn, Ni, Cr components that normally come with dosing Part 1.
MichaelW
New member
Yeah I think I will switch and just monitor 2 see what happens. Currently my dosing is way more for all with fauna marin balling lite. From my reading this is normal and most people do not dose equal.. The question becomes do I dose equal amounts of all three AF products based on my current all amount or calcium amount. I hope ca as it's way less
fessoclown
Dis-Membered
You should balance them first by dosing individually before using one of them, like alk, to dose them in equal parts using +1+2+3. This is what was shared with me by others.
MichaelW
New member
They are balanced.but currently they are kept in balance with no magnesium dosing and not equal quantities of fauna marin balling lite solutions. I actually don't know any one using fauna marin that doses equal amounts of all 3.
But to work out what the dose of all 3 AF products do you work off of alk consumption..for example I need 35ml of alk solution daily to keep alk where I want it, so I will dose 35ml of all 3 containers.
But to work out what the dose of all 3 AF products do you work off of alk consumption..for example I need 35ml of alk solution daily to keep alk where I want it, so I will dose 35ml of all 3 containers.
Aquaforest
.Registered Member
Component1+2+3+ contains microelements also that's why We are not recommend to dose individual Components to rise individual Macroelements.
Regards,
Aquaforest
MichaelW
New member
Yes this I understand, my question was about working out the dosage for all 3 containers is it best to work out amount needed to maintain alk and dose the other 2 the same? How about the fact I currently don't need to dose mg but it is included with calcium?
Aquaforest
.Registered Member
Didi You try to dose every components in the same dosage?
For example 150ml-150ml-150ml?
For example 150ml-150ml-150ml?
