Just updated my aquajr firmware to 1B06. I noticed that the statement "If Tmr Kal=on then Top=off" is not doing what it is supposed to do.
Kal is my kalwasser pump for the reactor and Top is the topoff float swtich to fill the reactor and then the sump. Both set to oscillate 5/55min and 2/58 min respectively. What used to haapen prior to the update was that the kal pump will turn on to mix which in turn stops the topoff float switch so I am not adding a concentrated solution of kal. Then when the kal pump is off, the topoff switch turn on and the RO water fill the reactor and then drip the solution into the sump. But now, both are on at the same time and the topoff water is too concentrated and messing up the pH. Any suggestions?
Kal is my kalwasser pump for the reactor and Top is the topoff float swtich to fill the reactor and then the sump. Both set to oscillate 5/55min and 2/58 min respectively. What used to haapen prior to the update was that the kal pump will turn on to mix which in turn stops the topoff float switch so I am not adding a concentrated solution of kal. Then when the kal pump is off, the topoff switch turn on and the RO water fill the reactor and then drip the solution into the sump. But now, both are on at the same time and the topoff water is too concentrated and messing up the pH. Any suggestions?
