ATI PM owners, is this normal?

[mnml]

I just received my 8x54w ATI PM and noticed this irregularity on the fixture. It's about a 2-3mm gap on each end of the fixture. The corners does not look like it's been dropped so I'm not sure if it was assembled like this.

Anyone else have seen this on their fixture? I wanted to find out if this was common before I contact ATI.

Thanks!

 

[rholguin]

I have a 48" ati sunpower and it does not have those gaps. The power module is the higher end fixture so I doubt those gaps are suppose to be there.

 

[Versus]

the couple of my 24 's do not have that also post in the reefgeek forum since they sell quite a few maybe they have seen it before?

 

[Montezuma]

I just got mine about 2 weeks ago, and it doesnt have that.

 

[mnml]

I was able to fix it. Took the end plates off, put it up against a 2x4 and took a small rubber mallet to it. Everything lined up with a few light taps. Good to go!!