cmpenney
New member
It seems that the power supply on one of my MP40s has gone bad. I noticed the other day that one of my pumps was pulsing like it was in wave mode( blue) but it was indeed set to continuous( Green ). I disconnected the power. cleaned the wet side just to make sure something wasn't sticking or causing a problem there. When I was done I reassembled everything and tried to power it back on. It started through the boot process but then went to a dim light and and the pump would not run.
I figured that my WWD must have failed on me. I've had 2 go bad in th past and so I installed my old driver back on to the pump( My WWD where upgrades) The pump powered on but once again it was pulsing and this time I noticed that the green light on the old driver was blinking in sync with the pulsing.
So it seems like the powersupply is not producing a steady output and that is the source of my problem..Where can I get a new powersupply?
I figured that my WWD must have failed on me. I've had 2 go bad in th past and so I installed my old driver back on to the pump( My WWD where upgrades) The pump powered on but once again it was pulsing and this time I noticed that the green light on the old driver was blinking in sync with the pulsing.
So it seems like the powersupply is not producing a steady output and that is the source of my problem..Where can I get a new powersupply?
