BakerReef Fish Room Project

Jbaker2290

New member
Hello, If you saw this forum previously, I had it removed as I realized I wasn't writing a topic that i would want to read myself and I was also having terrible trouble with photo hosting.

I learned a lot of salt water basics helping my mother with a couple 55g fish only tanks she had over the years. (Also learned everything you shouldn't do....undergravel filter, freshwater gravel, lava rock, no water changes, hippo tangs in 55g, never replaced filters:headwally:) She did not have the resources we have here today.

My first on my own tank was a 55g reef tank with a 10g sump & 10g refugium, had a chinese made t5 light, a sea swirl for return, 2 aqueon circulation pumps, super skimmer 125. I had a 20g QT setup, RO Unit, and Reefkeeper... went fairly well my biggest regret from the whole thing was using real live rock, had a ton of pest issues.

We moved, I switch to a 60g cube that fit the space better, converted the refugium to another sump compartment and bought another chinese made metal halide light, slowly began to upgrade this tank... switched the aqueon pumps for MP10Wes traded light out for a radion. Added a 40g sump with a reef octopus skimmer, started adding Kalk. Overall Learned A lot!

Then our living situation required us to take the tank down, mostly everything was sold off.

FINALLY! We have a house of our own and this is where the build begins!

We have a fairly good sized basement that will be converted into a fish room with the display facing the stairs and family room. Next Post Will Be What I want to have and then I will show you the small progress so far.:bounce1:
 
What To Have

What To Have

Main Tank
-Marineland 300g DD Starfire Front
-Will use stock drains and returns, Water level will be monitored by float switches in case drain clogs.
-Will be using custom wood stand

Circulation
-Not Fond of closed loops, will be going all Vortechs, amount TBD

Lighting
-Radion w/ TIR Lenses, Probably 6

Skimmer
-Very Fond of Reef Octopus Still Considering

Dosing
Will start with Kalk until its not enough, then probably a calcium reactor

Heating
TBD

Sump
Probably a DIY Sump with around a 150g

Fishroom
-I wanna say approx 10x10
-Separate HRV for air circulation
-Mold Resistent drywall, vapor barrier, Insulation
-Epoxy Floor Over Concrete
-Floor Drain
-Utility Sink
-Hose Sprayer On Spring Loaded Real On Wall
-Parameter Drains (For Tanks Etc)
-Separate Sub Panel, GFCI Outlets, High On Wall

Water Storage
-RODI Unit
-2 100g Storage Tanks
-Smaller Tank For Warming saltwater as needed as to not heat all 100g constantly
-All setup for filling and automatic water changes, no buckets

Automation
-APEX Everything HAHA

Quarantine
-3 40g Breeder, 1 Coral, 2 Fish, on wire shelving
-Main Tank waste water will drain into coral qt and then down to fish qt
-Ability to isolate any tank or add remove from constant water change
-Each tank drilled with two bottom bulkheads one for overflow stand pipe and one for complete drain
-Lighting for fish QT will be simple strip light DIY, and coral probably A Rapid LED ONYX controlled by pwm on APEX
-All separate Aquaclear Filters
-Seperate Heaters
-Aqueon circa pump in each fish QT
-2x MP10 for Coral QT
 
Back
Top