Battling Phosphates

G

GregJames

New member
System: RedSea Reefer 250 (55gal display)
Torch coral, wall hammer, branch hammer, GSP, and zoas.
Filtration is just filter socks and skimmer

I'm currently battling a nitrate spike for some reason, but my phosphates are up to .5 somehow šŸ˜³
What is the quickest way to bring them down safely, and what should my course of action be tomorrow when the LFS is open?
I'm currently mixing water to do a 15gal water change, but I don't believe that will fix my phosphate issue.

Temp - 77.2
Sal - 1.026
Nitrate - 80
PH - 8.0
KH - 9.3
Phos - .5
Mag - 1270
Cal - 500
 
You can try GFO for the phosphate issue. It will bring it down quickly but set up will cost due to needing a reactor. Since you mentioned nitrates are also high it may be best to use No3 Po4x from Red Sea. I was battling high nitrates and it did the trick.
 
Jas111 said:
You can try GFO for the phosphate issue. It will bring it down quickly but set up will cost due to needing a reactor. Since you mentioned nitrates are also high it may be best to use No3 Po4x from Red Sea. I was battling high nitrates and it did the trick.
Click to expand...



I'm actually considering running to the LFS tomorrow to pick one up...


Sent from my iPad using Tapatalk
 
It is similar to dosing vodka. I think it would be up to you if wanted to use it to correct the problem and then stop dosing and see what what happens. Like I said earlier I was battling high nitrates I was doing 20 gallons water changes twice a week with no real change to my problem. Started using nopox it took about a month and I went from over 50ppm to 2. Since I started using nopox I shut off my GFO reactor and I am not seeing any issues with phosphates. Just make sure your skimmer is dialed in.

It's not a quick fix but works.
 
I believe you are battling more than just phosphates. If the above post is true ^ and you used the same sand, you definitely stirred up the trapped gasses & nutrients. Hence you are fighting to get them down. I'm not one for resorting to chemical additions until absolutely necessary. Mostly because they address the symptoms not the cause of the underlying issue. Without lowering through skimming, water changes, and filter changes the undesired levels will climb again once the chemical dosing is halted.

Another possibility is what I am going through now with new sand and a few pieces of dry base rock. Whatever is inside them is being released and there is likely a mini cycle happening. Because the system is larger and filtration/skimming is sufficient there is no rise in ammonia or nitrites. The cycle is happening at a much more diluted rate but the end results (nitrates & phosphates) are slightly elevated thus the algae has a chance to show up.

In a few short weeks everything should level out. Just stay on top of things.
 
Yeah that's kind of what I figured with the move. I kept the sand in with about 4" of water and did it all as carefully as I could, but it must not have been enough.
Here's the problem though:
I deploy to the Middle East next week and will only be back for a few days every 3mo... The wife can do water changes, filter socks, skimmer, etc. All the basic stuff, but I have a professional coming once a month to keep it on track and do whatever needs to be done


Sent from my iPad using Tapatalk
 
GregJames said:
Well, we just moved about 2 weeks ago, so I'm wondering if the moved stirred stuff up too much and threw it all out of wack.

I'm using the Salifert test kits


Sent from my iPad using Tapatalk
Click to expand...


I would recommend a Hannah ULR Phosphorus checker. This will give you a more accurate reading at a much lower level. I shoot for .05 ppm and a regular phosphate checker won't go below 1.0. There is such a thing as too low a phosphate level so you want to be careful with GFO.
 
GregJames said:
I'm headed to the LFS tomorrow to pick some up, and possibly get a reactor as well


Sent from my iPad using Tapatalk
Click to expand...
I think, you should try Red Sea NO3:PO4-X, you need NOT to buy a reactor or pump. After few weeks, when you can control NO3, PO4, you may need a dosing pump

Best of luck
 
Tanthaitrung said:
I think, you should try Red Sea NO3:PO4-X, you need NOT to buy a reactor or pump. After few weeks, when you can control NO3, PO4, you may need a dosing pump

Best of luck
Click to expand...



That's kind of my problem.. I deploy to the Middle East next week, so the wife will be responsible for the tank. She can do basic maintenance, but gets lost in the chemistry side of it..
I do have a pro coming once a month to keep it in check, but I was just going to get a reactor as a peace of mind while I'm away


Sent from my iPad using Tapatalk
 
Oh. You also need a Hana HI736 to test PO4. Your NO3 is so high, most of GFO controls PO4 only. You may think about another simple method is chaeto with cheap led light
 
Tanthaitrung said:
Oh. You also need a Hana HI736 to test PO4. Your NO3 is so high, most of GFO controls PO4 only. You may think about another simple method is chaeto with cheap led light
Click to expand...



Yeah I think I've got the nitrates under control now after a couple 10gal water changes, deep cleaning, and tuning the skimmer.
I'm fairly certain that got jacked up because we moved the tank to a new house and disturbed the sand bed


Sent from my iPad using Tapatalk
 
I did close to that and they're barely registering now. I'll test again in the morning before I go get the Red Sea NO3:PO4-X


Sent from my iPad using Tapatalk
 
You must log in or register to reply here.

Similar threads

T
Tank Crashing
Replies
14
Views
233
brandon429
brandon429
M
Frogspawn Issue Help.
Replies
10
Views
1K
MNtadpole
M
Formulator
8 year old tank with 2.0 PO4 and zero Nitrate
Replies
7
Views
2K
Scotty333!!!
S
J
Phosphate Drowning My System
Replies
7
Views
1K
Timfish
Timfish
N
5 ppm nitrates 0 ppm phosphate dinos and hair algae taking over 8 year old tank
2
Replies
23
Views
3K
369Augold
3
Back
Top