I have a brand new 6105 that's been running for less than a week. First few days, no problems. I noticed yesterday that it had stopped. I took it off, removed the shroud (6205) and didn't see anything wrong with the impeller. Put it back in and it started up again. I just noticed today that it stopped again. About every 10 seconds, it tries to start by "quivering". The impeller moves just a fraction, one direction then back a second or two later.
It's running on a Profilux controller, pulsing from 30% to 90%.
Any suggestions?
It's running on a Profilux controller, pulsing from 30% to 90%.
Any suggestions?
