christyf5
New member
Hi,
Sorry this may seem like a lame question but I'm a bit confused as to all the parts of the tunze 6060 drive/impeller combo.
As I was cleaning the impeller one of the "brake shoes" fell out. The other was already gone I suppose, either that or it went down the drain. I crammed it back in but to no avail, it later fell out again at some point (not sure where it went). Anyway, the blade no longer turned. I did try supergluing the white plastic part (drive shaft?) to the drive unit but it still doesn't go, it does turn but not very fast and seems to create a suction rather than flow (turning the wrong way I guess). Anyway, obviously I need a new part however I'm not sure which part do I need to replace in order to get the brake shoes??
Thanks for your help. I hope you understand what I'm talking about
Christy
Sorry this may seem like a lame question but I'm a bit confused as to all the parts of the tunze 6060 drive/impeller combo.
As I was cleaning the impeller one of the "brake shoes" fell out. The other was already gone I suppose, either that or it went down the drain. I crammed it back in but to no avail, it later fell out again at some point (not sure where it went). Anyway, the blade no longer turned. I did try supergluing the white plastic part (drive shaft?) to the drive unit but it still doesn't go, it does turn but not very fast and seems to create a suction rather than flow (turning the wrong way I guess). Anyway, obviously I need a new part however I'm not sure which part do I need to replace in order to get the brake shoes??
Thanks for your help. I hope you understand what I'm talking about
Christy
