Building a Sump.. Need Help!!!

Xler8n

New member
I am going to build a sump in the near future and have someone selling me a very new 30 gallon tank for $30. My question is will the 30 gallon fit under my wooden stand. My stand has double doors on it and has a center support brace between the doors. It looks to me like i will have a hard time fitting it under the tank and into the stand.. Will i have to take off the center support or should it fit with a little manuverung??

Its a 75 gallon RR. Inside the stand the dimensions are as follows. 45 1/4" X 15 1/4" X 26". There is a brace in the stand going from front to back that is about 23 1/4" from bottom of the inside of the stand to the bottom of the brace... I will put the skimmer on the side where the height is 26". There are two doors and the openings in each door are 15 1/2" Wide and 21 1/2" Tall. ive ben told with a little manuevering it will fit.
 
Pictures would be a little more helpful, but to be honest... I probably wouldn't remove any load-bearing supports underneath the main tank. I had the same issue with my homemade sump, because the 10 gal tank was only a couple inches too long. I considered making a smaller sump somehow, but instead I decided to go with the 10 gal, and place it to the side and below of the main 55 gal tank.

What are the dimensions of the 30 gal tank?
 
It likely won't fit thru the front doors with the center brace.

Options:
1. Make center brace removable via L-brackets. Would require draining tank at least 3/4 to be safe during install.

2. Install from rear. Likely require tank breakdown.

3. Cut opening thru side panel & add a cabinet door. This will allow the sump to be installed or removed for maintenence without worry. This is by far my favorite.
 
I said 30 gallon not 30L or Breeder. Anywayz. I dont have enough room on the sides of my tank to do it from the side so ill most likely removed the center brace... What do u mean with L brackets??
 
Back
Top