sonomanapa
Premium Member
I bought a Profilux II system a few weeks ago and finally got it installed this week. I immediately upgraded to the beta software just to be able to better control my Tunze 6055s. Temp, PH and the digital 6 bar also work great. Only question I have is with my 4 socket bar. I am unable to control S1, and S2. Socket 9 is always on, and 10 is always off. I tested via my laptop serial control with the latest 3.062 beta controller. Disconnected it, reconnected it, rebooted the profilux, tried it plugged into S1-S4 on the controller, and still cannot control those two outlets. I also opened it to see if the fuses were still functional. These test were done with no load only a circuit tester plugged into the questionable outlets. Bad bar?
On higher note love the system, and hope to order the flash bar, L5-6 upgrade, and the WLan upgrade.
Power Bar info
Model STDL 4-4-usa-cd
SN 0612470043
Thanks
On higher note love the system, and hope to order the flash bar, L5-6 upgrade, and the WLan upgrade.
Power Bar info
Model STDL 4-4-usa-cd
SN 0612470043
Thanks