Can Pulse Mode remember settings after switching modes?

[lactose]

Hi-

My question is this.

I can get a decent wave going with one vortech in my tank but it takes a good bit of dialing in (and I am fine with this). For illustration sake lets say the speed is set to 75% and the frequency to 25%. Once I have that set all is good and the settings will survive a power on/off cycle.

However I normally keep it at reef crest mode. If I get the wave mode all tuned right, and then swap to reef crest and adjust speed to say 100%, if I later switch back to the pulse mode it appears I need to do the dialing in procedure again to get it right.

Am I missing something? This makes it hard to switch back and forth from pulse without taking the 10 minutes to dial in and therefore makes it hard to demo to folks visiting quickly as well.

Thanks.

 

[IceCap Service]

Once you change modes, the pulse mode will have to be reset when you return to it. It will remember the settings if the pump is unplugged or power is lost but changing modes will cause you to have to reset pulse settings.

 

[lactose]

Thanks, at least I am not crazy. Please consider this a request for an feature then

 

[EcoTech Marine]

<a href=showthread.php?s=&postid=11668923#post11668923 target=_blank>Originally posted</a> by lactose
Thanks, at least I am not crazy. Please consider this a request for an feature then

Noted.

-Tim