controller 7095 question

[gigiba]

I have the setup for about a year now. Two 6100 pumps and one on each channel.
My setting were interval 2, min 30%, max 100%. Night mode and moonlight are used. This has been running for about a year.

few days ago, I changed the min to 60% for both channels and both channels' amber light were showing 60% for the min.

Today, I noticed channel 1's amber light is back down to 30% even tho the min setting is at 60%. I did a small test by powering off the whole thing and turn it back on. This time, channel 1 is ok and running at 60% at min but channel 2's min is back down to 30%. Therefore, I am sure both pumps are good. Now the question - Is it normal for the controller acting like this?
if yes, is it possible for both pumps running at 60% min at the same time.

Thanks

 

[rvitko]

In Interval 2, the pump that would be off in Interval 1 instead idles at 30%, when it is it's turn to run it should pulse from 60-100% as you have set it. If you use pulse mode you can run them as you want.

 

[volivier]

i also have that controller and 6100's i bought used here on RC. is there a place online for directions for the controller?

 

[rvitko]

You can download the PDF on tunze.com

 

[gigiba]

at interval 2 and light off, should they both run at 60%?

currently, one will be at 60% and the other will be at 30% when the lights are off.

 

[rvitko]

Yes, that is normal, interval 2 idles one pump at 30% regardless of what you set. It is just like interval 1 except the pump that would be off in interval 1 idles instead.

 

[gigiba]

cool, Thanks for the reply.