Could use some help with magnets for my 6100's

[Tony44]

About a year ago I bought two used Tunze 6100's along with two magnet holders. My plan was to use them on a new tank that I would be setting up, now after a year I am finally in the process of setting up this new tank. When I got the pumps I took them out of the box and played around with them a little bit, trying them on my 125 that I had at the time. At this time I got everything working fine, and all the pieces were there.

I just dug the box up out of the garage after being stored for a year, and I just tried to setup the pumps. As dumb as this sounds, I can't seem to figure out how to install the magnets onto the pumps. I hope this isn't the case, but it seems like some parts might be missing, I also don't have the instruction booklet.

Is there any chance someone could post something that shows how to install the magnets? Or a PDF or link to an instruction manual?

This would be greatly appreciated.

Thanks!!

 

[shawnz28]

http://www.tunze.com/fileadmin/gebrauchsanleitungen/x6200.5088.pdf

You will need 2 parts. The 6080.23 sliding piece which slides onto the magnet, the 6080.40 arm on the pump. If you enter those part numbers into the search on tunze.com you can see pics

 

[Tony44]

Thank you.

After looking at that and installing one of the holders, I now see that I am missing one of the holders.

Thanks for the help.

 

[Tony44]

I don't know if this is the place to ask, but might anyone have a 6200.50 magnet that they are selling?