Dart Closed Loop Plumbing

[elephen]

I have been setting up my new AGA 120 (4x2x2).

I finished all the plumbing gluing and all last night and went to fill up the tank with tap water to inspect my plumbing for any leaks and I have a union that has a very nice leak, a constant run. The rubber gasket is in there but the PVC does not line up good which I believe is the culprit for the leak.

I am just about fed up with this darn stuff so I am contemplating on tossing ALL the old out and go with something like this.

Here is a shot of the old plumbing (1/2 of it atleast)

What do you think of the new setup, I think its more simpler for sure.

 

[elephen]

Bump

 

[jeffbrig]

Before I went through the effort of redoing everything, I'd replumb just the section with the bad union using flex PVC. That should take care of any slight misalignment, and hopefully cure the problem.