Directions to calibrate an EB8

[Deleted member 143833]

Before starting you need to get the address of the EB8 you want to calibrate and verify there there are no outlets turned on (aka; nothing connected OR all outlets set to manual off).

You will need to use telnet and connect to the Apex.

Once connected enter the following command to set the zero point:

eb8zero 3

replace 3 with the address of the EB8 you wish to calibrate.

Note: EB4 uses the same command

 

[aquamanic]

I was wondering when you were going to get tired of sending those PM's back!

 

[aquamanic]

The User Guide has information on Telnet for those that don't know how to use it.