driver setting and mounting questions

[jmaneyapanda]

Dear Roger:

A couple quick questions-
First, for a 6000, the screw setting on the side of the driver- does this need initial adjustment of using the 6000 with a 7095? Does it have a factory pre-set? Will I need to tweak it?

Secondly-When mounting the 6000 to the swivel mount, I am confused on how to attached this with the screws included. When I put a screw through, and a nut on the other side, it just pulls through. Am I missing something? Also, when mounting the swivel base to the magnet mount, is there a way to secure the clip to the magnet? There is no hole to accept the spring button to lock the swivel mount.

 

[collins]

you will need to buy some nylon washers - I had the same problem.

The screw on the driver needs to be full open. I think they come set like that, but it doesn't hurt to check.

The weight of the stream will keep it in place on the magnet mount.

 

[rvitko]

The screw mount is only for the 6200, the needed threaded post and 8mm screw are not included with the smaller pumps and not required. Just be sure the teeth on the post and arm are meshed firmly and it shouldn't move.