Dual Inline TDS Meter

[Joe]

When I cut my inbound and outbound lines, and insert the plastic water lines into the plastic tees, how are the lines held securely? I don't need any leaks!!!

TIA,

Joe

 

[einsteins]

Make sure you push the line into the T fitting very firmly....they are quick connect fittings and if the tube is pressed all the way in the right way they wont leak.

GL einsteins

 

[besl]

I believe it is a quick disconnect fitting on those where you push the end of the fitting in and then push the tube into the fitting. When you release the quick disconnect it will grab the tube securely.

 

[Joe]

Many thanks!!! I'll jam them in there tonight.

Joe

 

[prugs]

They make locking collars for those John Guest fittings if you are worried.
http://www.rosystems.com/mm5/merchant.mvc?Screen=CTGY&Store_Code=RSI&Category_Code=JGLC
I don't recommend this business as a source, lots of places sell them.

 

[Joe]

Thanks for the additional info., prugs. I hooked the thing up last evening, and the inlet "T" does leak, as I figured one or both may, with my luck.

Joe