ESL for Vortech on a MAC

[Fishie80]

I just added my vortechs to my reeflink and i am unable to change(increase or reduce) the timeline (end time) for any of the modes

i can delete or change settings of a mode...but i just cannot get it to change the time that it runs for

when i try to extend, it ends up swapping places with the next mode.

is this a known mac issue

i have tried this on safari/chrome and firefox on my mac.

 

[DonaldLL]

Mac user here... first I delete all modes and whatever is left I start from there. Once you have 1 mode for the entire 24 hour cycle you are ready to begin. i've found that if I take the mode i want to use first in the timeline starting from the left, drag that into place on the left (beginning) of the timeline. Then drag the next mode on top of the first mode and 'to the right' of the existing 1st mode. Set the start time on this 2nd mode and let the end time extend to the end of the 24 hour period; then overlay the 3rd mode on top of the 2nd mode but 'to the right' the second mode; set the start time on this second mode and disregard the end time. Keep overlaying modes left to right and each time set the start time of the new mode and it will truncate the previous mode which will basically set the end time of the previous mode automatically as the start time of the next mode. The simple instructions are: keep fiddlin' with it you'll see what I mean. Each new start time by default creates the end time of the previous mode

 

[Fishie80]

thanks that did it...

 

[Fishie80]

ok i have one more question

why is there a max speed option in sync or anti sync

doesn't sync copy what the master does anyways...so if at 2-3am its running lagoon at 30% won't my sync'd one do the same

not sure i understand why max speed is needed for slaves...unless it is to prohibit it from going higher than what the master is scheduled to run at