dead beat reef
New member
Easy low buck mods to place Fission in 2nd chamber of Aqua Pod
12. All you need is a 11/16th drill bit and hacksaw blade. The
elbows that come stock are to long. Cut them back about 3/4
of an inch. Elbow to power head leave 1/4 inch so it will fit
over output. Elbow to skimmer body cut than use drill bit to
increse inside di. till it fits over input. Just turn drill bit by hand
gently alittle at a time. No drill motor.
Turn power head sideways and remove cone. Its
ready to install. To hold water level in 2nd chamber I removed
about 2 and 1/4 inch of overflow wall between chambers 2 and 3.
Lots of picts. in gallery. It works. Check it out.
12. All you need is a 11/16th drill bit and hacksaw blade. The
elbows that come stock are to long. Cut them back about 3/4
of an inch. Elbow to power head leave 1/4 inch so it will fit
over output. Elbow to skimmer body cut than use drill bit to
increse inside di. till it fits over input. Just turn drill bit by hand
gently alittle at a time. No drill motor.
ready to install. To hold water level in 2nd chamber I removed
about 2 and 1/4 inch of overflow wall between chambers 2 and 3.
Lots of picts. in gallery. It works. Check it out.
