MarineFishGuy
Capn Jack Sparrow
When I saw Porky say that most people lacked the Tools to make these I said Game On. I guess I am not most people.
With some extra acrylic I had lying around and nothing more than the tools in my garage, I threw this together.
There are a few chips around some of the holes and on the front edge, but they do not affect the function and I am not a vain person.
It is 21" x 5" and holds 35 frag plugs.
I used a Large Magnet Cleaner to hold it in place because I have 1/2" glass and 10 3/4" x 1/8" Epoxy coated magnets were not enough. The Pull force between two of these magnets is 36lbs at 0". At 1/2" it was only 0.28lbs though. Magnets are the most expensive part of the entire project. I only used $7.50 worth of acrylic.
If you want to see what was involved in putting this together, you can see the full thread If you want to talk about it here, feel free to do so, but please don't direct traffic off-site. - Anemone
With some extra acrylic I had lying around and nothing more than the tools in my garage, I threw this together.
There are a few chips around some of the holes and on the front edge, but they do not affect the function and I am not a vain person.
It is 21" x 5" and holds 35 frag plugs.
I used a Large Magnet Cleaner to hold it in place because I have 1/2" glass and 10 3/4" x 1/8" Epoxy coated magnets were not enough. The Pull force between two of these magnets is 36lbs at 0". At 1/2" it was only 0.28lbs though. Magnets are the most expensive part of the entire project. I only used $7.50 worth of acrylic.
If you want to see what was involved in putting this together, you can see the full thread If you want to talk about it here, feel free to do so, but please don't direct traffic off-site. - Anemone
Last edited by a moderator:
