Frag saw needed to use.

[CrippledStoner]

Have few corals to frag up. Who has a saw or does the club have one I could use for a day or two.

 

[lokii_37]

Oh boy!! What are you fraging up?

The saw is still at bobs house.

 

[CrippledStoner]

Got a chalice and few zoas got also yellow turblnia to chop up. How or whats bobs handle or phone so can contact him. Been thinking about buying the Inland frag saw or fork out another 200 and get gylphon say from brs. I know fish pros have the inland and is always having problems with blade popping off track.

 

[Reef Bass]

How or whats bobs handle or phone so can contact him.

Thysrof. He's usually lurking.

2 fixes to the Inland throwing its blade. Adjusting the angle screw in the back can also make a huge difference. Make sure the upper bearing is spinning freely. Disassemble and lubricate if not.

 

[woodnaquanut]

Robert, there's a few things I'd like to try with it too. Let me see if I can get Bob's attention and pry the saw away from him.

To add to reef bass's comments...
There is a blade guide that should be adjusted so it's as close to the table as possible. It supports the blade so it doesn't flex as much when cutting.

Also it's important not to rush the cut. It's a little saw made out of plastic, mostly. It can not handle a cut that taxes it's capacity. Just like big beefy 1000 lb. woodworking tools, sharing among unskilled users is hard on them. I'll bet that is most of the problem at FPro.

It's such a cute little saw. I imagine it being used by Ken in the garage of Malibu Barbie's beach house!