Hey RC members,
It’s been a little while but here I am posting again. Texas is my new home but I still have items to get rid of before the BIG move. I hope to get back into the hobby once everyone is settled in.
Again, thanks to all here at RC for your input on my first saltwater tank venture a few years back. Even though we may not have communicated directly, your postings were/are inspirational and exciting. A special thanks to the fellow SEASL members for putting up with all the question/answer sessions during the process.
OK folks, here is the last list of stuff.
All items have been used at some time except as noted. All items functioned properly at the time the tank was broken down except as noted. WET items have not had water in them for over two years. Some items may need to be cleaned prior to loading them in your vehicle, I’ll help, of course.
Octopus 3000 and various probes/control modules, asking $350.
GEO 618 Calc Reactor, CO2 tank, regulator, feed pump, and extra media, asking$350.
Sequence 3200SEQ20 with saltwater seals...never used, asking $250.00
Sequence 5800SEQ23 with saltwater seals (some plumbing included), asking $300.
72 in PFO Deluxe custom black light hood
Includes 3 x MH mogul and 2 x 160W VHO black hood, two fans, two Ushio 10K 400W, one Hamilton 14K 400W, 2 Uri VHO super actinic bulbs. MH bulbs about 3 months usage. Actinics about 8 months usage. One PFO dual 440 watt ballast, one PFO single 400W ballast and one PFO dual VHO ballast, asking $600 OBO.
Two custom-made acrylic frag tanks.
Each are 48 in L X 24 in W X 12 in H, ¾ inch acrylic with rounded edges, one black acrylic overflow on one 24 in side, already drilled with one inch-and-a-half drain out of the side, includes a schedule 80 bulkhead for each tank, asking $250 each / $450 both OBO. You can also have the home-built stand if you want both tanks. Stand is 96 in L X by 24 in W X 40 in high made of doubled up 2X4 and ¾ plywood.
Two ¾ inch Sea Swirls.
Includes one Y-fitting, two round and two flare nozzles for each unit, asking $50 each. May need some repair work.
CustomSeaLife 72 in Power Compact light unit about one year old.
Uses 2 x 96W square-pin bulbs. Includes extra bulbs, asking $50.
Two All-Glass 36 in double tube strip light units, fake wood grain/black.
Uses two 36 in normal output bulbs. Includes extra bulbs, asking $25 each unit w/bulbs.
Aqualogic 1/3 hp flow through chiller.
Includes Medusa single stage, 2 digit controller asking $500.
Ecosystems large (36 in X 16 in X 18 in) glass sump. Includes bio-balls, lights, bulkheads. Two one-inch holes drilled w/bulkheads on return side. Might have two 10 lb bags of MM to include, asking $250.
LifeReef dual tower sump
LF2-300, 41 in L x 13 in W x 22 in H with side-by-side towers. Includes the two towers, bio-balls, 3 chemical media filter cylinders, and all necessary bulkheads for four one-inch returns and one inch-and-a-half skimmer drain, asking $250.
Custom acrylic sump 24 in H x 24 in T X 60 in long. Three baffle areas, no holes drilled on any sides, still in plastic wrap, asking $300.
AquaUltraViolet 25W UV sterilizer.
I have two of these, one wiper-type, one not. Both need bulbs, one needs an O-ring on the ballast end, 3/4 inch ports asking $50 each.
MISCELLANEOUS ITEMS
One 20 gal high with hood and light strip, asking $35.
One wrought iron stand, will hold two 20 gal high tanks, asking $20.
Several Maxijet 900 and 1200 powerheads $10 and $15 respectively.
Several Visi-therm heaters 200 and 300 watts. A dollar a wattââ"šÂ¬Ã‚¦JK, $10 and $15 respectively.
A bunch of other supplies such as additives and food while it lasts.
Lots of PVC plumbing pipe, bulkheads, elbows, connectors, etc. Bring buckets, make offers on these items. If Lowes/Home Depot is out of an item that’s because I bought five when I only needed two, just in case. You know the deal.
NOTE: Most items may also be available for viewing in my gallery, to some degree or another. All tanks/sumps that have bulkheads installed now will come with bulkheads. All reasonable offers will be responded to in the order I received them, within a day or two. If you see something you want, you may want to make some kind of arrangement while it is available. Sorry, items are for local St. Louis pickup only. You are more than welcomed to come by and view any item(s). I will try to respond to your questions ASAP. Send me a PM if you are interested in any item(s) so arrangements can be made. I’ll send you my phone number and we can talk. Make a REASONABLE offer on multiple items and you never know what might happen. Right Tom?
Cash and carry. Money talks and...you know the rest.
Thanks for reading and by all means have fun.
Ron
It’s been a little while but here I am posting again. Texas is my new home but I still have items to get rid of before the BIG move. I hope to get back into the hobby once everyone is settled in.
Again, thanks to all here at RC for your input on my first saltwater tank venture a few years back. Even though we may not have communicated directly, your postings were/are inspirational and exciting. A special thanks to the fellow SEASL members for putting up with all the question/answer sessions during the process.
OK folks, here is the last list of stuff.
All items have been used at some time except as noted. All items functioned properly at the time the tank was broken down except as noted. WET items have not had water in them for over two years. Some items may need to be cleaned prior to loading them in your vehicle, I’ll help, of course.
Octopus 3000 and various probes/control modules, asking $350.
GEO 618 Calc Reactor, CO2 tank, regulator, feed pump, and extra media, asking$350.
Sequence 3200SEQ20 with saltwater seals...never used, asking $250.00
Sequence 5800SEQ23 with saltwater seals (some plumbing included), asking $300.
72 in PFO Deluxe custom black light hood
Includes 3 x MH mogul and 2 x 160W VHO black hood, two fans, two Ushio 10K 400W, one Hamilton 14K 400W, 2 Uri VHO super actinic bulbs. MH bulbs about 3 months usage. Actinics about 8 months usage. One PFO dual 440 watt ballast, one PFO single 400W ballast and one PFO dual VHO ballast, asking $600 OBO.
Two custom-made acrylic frag tanks.
Each are 48 in L X 24 in W X 12 in H, ¾ inch acrylic with rounded edges, one black acrylic overflow on one 24 in side, already drilled with one inch-and-a-half drain out of the side, includes a schedule 80 bulkhead for each tank, asking $250 each / $450 both OBO. You can also have the home-built stand if you want both tanks. Stand is 96 in L X by 24 in W X 40 in high made of doubled up 2X4 and ¾ plywood.
Two ¾ inch Sea Swirls.
Includes one Y-fitting, two round and two flare nozzles for each unit, asking $50 each. May need some repair work.
CustomSeaLife 72 in Power Compact light unit about one year old.
Uses 2 x 96W square-pin bulbs. Includes extra bulbs, asking $50.
Two All-Glass 36 in double tube strip light units, fake wood grain/black.
Uses two 36 in normal output bulbs. Includes extra bulbs, asking $25 each unit w/bulbs.
Aqualogic 1/3 hp flow through chiller.
Includes Medusa single stage, 2 digit controller asking $500.
Ecosystems large (36 in X 16 in X 18 in) glass sump. Includes bio-balls, lights, bulkheads. Two one-inch holes drilled w/bulkheads on return side. Might have two 10 lb bags of MM to include, asking $250.
LifeReef dual tower sump
LF2-300, 41 in L x 13 in W x 22 in H with side-by-side towers. Includes the two towers, bio-balls, 3 chemical media filter cylinders, and all necessary bulkheads for four one-inch returns and one inch-and-a-half skimmer drain, asking $250.
Custom acrylic sump 24 in H x 24 in T X 60 in long. Three baffle areas, no holes drilled on any sides, still in plastic wrap, asking $300.
AquaUltraViolet 25W UV sterilizer.
I have two of these, one wiper-type, one not. Both need bulbs, one needs an O-ring on the ballast end, 3/4 inch ports asking $50 each.
MISCELLANEOUS ITEMS
One 20 gal high with hood and light strip, asking $35.
One wrought iron stand, will hold two 20 gal high tanks, asking $20.
Several Maxijet 900 and 1200 powerheads $10 and $15 respectively.
Several Visi-therm heaters 200 and 300 watts. A dollar a wattââ"šÂ¬Ã‚¦JK, $10 and $15 respectively.
A bunch of other supplies such as additives and food while it lasts.
Lots of PVC plumbing pipe, bulkheads, elbows, connectors, etc. Bring buckets, make offers on these items. If Lowes/Home Depot is out of an item that’s because I bought five when I only needed two, just in case. You know the deal.
NOTE: Most items may also be available for viewing in my gallery, to some degree or another. All tanks/sumps that have bulkheads installed now will come with bulkheads. All reasonable offers will be responded to in the order I received them, within a day or two. If you see something you want, you may want to make some kind of arrangement while it is available. Sorry, items are for local St. Louis pickup only. You are more than welcomed to come by and view any item(s). I will try to respond to your questions ASAP. Send me a PM if you are interested in any item(s) so arrangements can be made. I’ll send you my phone number and we can talk. Make a REASONABLE offer on multiple items and you never know what might happen. Right Tom?
Cash and carry. Money talks and...you know the rest.
Thanks for reading and by all means have fun.
Ron
