cschweitzer
New member
Well, I might as well post this, as I don't think I'll be using it anymore. This is a 6-stage Water General RODI system. It has a sediment filter, 2 carbon filters, the RO filter, the DI filter, and a last stage carbon filter. The filters are still good and after a couple minutes of running, it still pushes 0PPM output. I would recommend that the filters be replaced to have optimal performance. The DI resin could use replacement (about $6 per refill), as could the carbon and sediment filters ($30 for all four filters). The RO filter should be fine, as this unit was run on intake water of less than half the TDS of normal intake water(about 140PPM where the filters lives are based on an average of 300PPM). It has the faucet attachment with aerator. There may be a few things needed to purchase to make it work the exact way you would desire, but it is a great initial setup and has been working perfectly for about two years now.
The reason I'm selling is because I upgraded to a unit with a storage tank and two outputs so that my drinking water does not use my DI resin, but instead uses the final carbon stage.
The reason I'm selling is because I upgraded to a unit with a storage tank and two outputs so that my drinking water does not use my DI resin, but instead uses the final carbon stage.
