Ok so I had this dream last night which said to use the entire piece of left-over acrylic...
The plan is to put together a 480 plywood tank, 48" x 96" foot print and 32" tall with a 1/2" acrylic front panel. Though only put water up to the 24" mark. The plan is to have a shelf at the one end and set up a little plant area and waterfall.
Ok, this is a FW setup, but looking for advice on trying this out. I have done 8' x 24" high plywood/acrylic tanks before but never tried to take it higher and leave the water level lower.
Any thoughts/feedback would be appreciated. Thanks.
The plan is to put together a 480 plywood tank, 48" x 96" foot print and 32" tall with a 1/2" acrylic front panel. Though only put water up to the 24" mark. The plan is to have a shelf at the one end and set up a little plant area and waterfall.
Ok, this is a FW setup, but looking for advice on trying this out. I have done 8' x 24" high plywood/acrylic tanks before but never tried to take it higher and leave the water level lower.
Any thoughts/feedback would be appreciated. Thanks.
