Got pics of your dorso or stockman setup?

[rykwong]

My corner return is 1.5 inches. I cannot fit a Dorso 1.5 inch into the space. Should I just go with the stockman setup? Or should I just reduce the size to 1.25 or even 1 inch to fit it in there? Thanks!

Rich

 

[Bebo77]

you can use a smaller pipe but that will reduce your flow...

 

[rykwong]

Yea that's why I'd rather just leave it at 1.5inches. I guess the stockman works fine? Do I just make it like this one?

http://www.rl180reef.com/pages/stan...en_stockman.htm

Thanks!

Rich

 

[JenDub]

www.dursostandpipes.com

 

[SirLight1337]

you may need to modify the actual fittings to fit in the overflow box.

I hacked up the elbow and 3 way split with a nice saw. no need to glue it.

 

[818]

Im sure u can do it. The 90 degree fitting on here is a 3/4 that went inside a 1' SCH40 PVC, I have to silicone it in since its so small....Just dont reduce it youll get the gurgling action still if you reduce it to much....The hardest part was getting the perfect size hole on the endcap...Start off with 1/16 hole and work your way up untill their is no noise from the drain..

Get a 90 degree fitting cut where it bends, silicone in only the piece that is needed to reduce noise...Ill try and get a picture of what I mean...

Good Luck

 

[NicoleC]

The Stockman will work.

 

[codybug]

Maybe this site will help.

http://www.nautilusreef.com/html/cjstandpipes.html

 

[jeffreylam1132]

Anybody got a website for the stockman?

 

[rykwong]

I had put up the link...look up

 

[tigerczr]

Your 1.5in will fit just fine. You can't see mine all the way because of the other PVC, but you can see at the bottom how I joined 2 45's to make the new angle.

 

[rykwong]

Thanks for all the advice and pics everyone!

 

[rykwong]

I just made a 1.25inch dorso. Looks really good. Thanks for the pic Tiger, that's exactly how I made mine fit.

Rich

 

[rykwong]

Hey, how do you guys post pics under the 50K limit? Thanks!

Rich

 

[tigerczr]

No problem...glad to be of help. I use photobucket and don't worry about the size issue.

 

[slavearm]

You can use a street ell 90 instead of a regular one, and trim both the Tee and the 90. They don't need to be that tight. That is how I fit mine in.

Slavearm

 

[golfish]

Here's a 1.5" Stockman

 

[seamist]

Golfish - could you make me one, I will pay.

I need one too, I have to putt pads inside the overflow to slow down the water.

Thanks

 

[golfish]

If you bring me the 3" coupler, 3"- 1.5 reducer and 1.5" end cap I can knock it out in 5 minutes.

 

[DRC69]

Nice work. I'd buy one from you to. I wish you where closer.