Doing joeys led light strip with PVC and drain gutter, my problem is the PVC started to get heated and the PVC started to bow down(bend). Wondering how I can prevent this bowing of the PVC to happen. I had a drain gutter, spray painted the outside, reflective tape on inside, mounted PVC pipe to the drain inside, wrapped the led light strip to the PVC. The PVC ended up bending. Any other ideas how to fix my led light strip onto my tank? Can I use something other than PVC to prevent the bending?
Help DIY PVC drain gutter led light
- Thread starter Fishboy15
- Start date
mcgyvr
New member
Whats a joeys led light strip with pvc/drain gutter?
Sounds ghetto..
If the PVC is overheating you need to move the heat source away from it or shield it..
But since I have no idea what you are doing I can't offer any valid suggestions..
And PVC can give off very toxic gas (dioxins,etc..) when heated/on fire.. So Don't do that..
Sounds ghetto..
If the PVC is overheating you need to move the heat source away from it or shield it..
But since I have no idea what you are doing I can't offer any valid suggestions..
And PVC can give off very toxic gas (dioxins,etc..) when heated/on fire.. So Don't do that..
NS Mike D
New member
mcgyvr
New member
Just because I'm handy doesn't mean my output is ghetto :lolspin:
This is what I'm talking about, my PVC started warping. Any help after watching video below?
http://youtu.be/_EYC3obFY4w
http://youtu.be/_EYC3obFY4w
mcgyvr
New member
Ok so do you have the supports shown at 6:00?
Have you tried increasing the number of supports to better "support" the pipe to prevent it bending?
You could replace the PVC with aluminum tube from home depot,etc.. It would keep the LEDs cooler too.. Its like $10 a tube..
Check out the shower rods too.. cheap.. aluminum..tube..$6
That makes it really "DIY" and handy and just the right amount of ghetto :lol:
http://www.homedepot.com/p/Glacier-...ilders-Shower-Rod-in-Chrome-HD14016/205699635
Have you tried increasing the number of supports to better "support" the pipe to prevent it bending?
You could replace the PVC with aluminum tube from home depot,etc.. It would keep the LEDs cooler too.. Its like $10 a tube..
Check out the shower rods too.. cheap.. aluminum..tube..$6
That makes it really "DIY" and handy and just the right amount of ghetto :lol:http://www.homedepot.com/p/Glacier-...ilders-Shower-Rod-in-Chrome-HD14016/205699635
NS Mike D
New member
Ron Reefman
Active member
What are you going to use this for?
I hope it's a FOWLR or as an addition to good leds because that isn't ghetto, it's trash if you are trying to keep corals under it.
I hope it's a FOWLR or as an addition to good leds because that isn't ghetto, it's trash if you are trying to keep corals under it.
djbon
New member
Your live rock should be ok. You might get something growing out of it, filter feeders, sponges, worms etc. No photosynthesis coral will ever grow under rope LED, but you can try non-photosynthesis corals with proper foods.
Similar threads
