Help mounting Apex Lunar Simulator Module lights

[vitodog]

I have 2 Radions over my 90 gal (no canopy). I want to incorporate the Apex Lunar Simulator (4 lights). My light rail is a prototype of the one devised by the guys from BRS on their video. I'm thinking I can place them on each corner of the actual radion fixture utilizing velcro. Anyone see a problem with this and or offer any other suggestions/advise?

 

[vitodog]

Anyone out there using these moon lights with their Radions? How are you mounting them?

 

[nbelohlav]

posting a pic may help get a better response....

 

[EdMan71]

I also hard trouble mounting mine. I used zip ties attached to return plumbing. Never was pleased with my mounting.
I was dissapointed on what little light they put out though. I had the 6 light set but on a 220 gal, so maybe to big of a tank.

 

[vitodog]

EdMan71, thanks for your response. I went ahead and used the velcro (the small square type) slightly smaller than the light and placed them diagonally on each radion (2) 4 lunar lights in all. They look ok and the light put out by the lunar's is fine for my tank (90 gal) however, i'm not sure I have them programmed correctly. After the initial connections were made, and the module was initialized, the lights came on and remained on for some hours and turned off sometime during the night. When configuring the light "If Moon 000/000 Then ON" do I have to input a certain time I want the lights to begin the cycle or just leave it as is?

 

[vitodog]

I got the answer to my questions. Just want to say thank you to all who responded. Thanks again.