How do install a Recirculating CO2 scrubber to my Tzune 9410 Skimmer?

[Los01]

How do install a Recirculating CO2 scrubber to my Tzune 9410 Skimmer? What I am not sure of is what connects to what, I have a general idea of how it should go (see diagram).

What do I with the ozone inlet, how do I adjust air volume? Should put a "T" connect on the hose coming from the scrubber and send one line to the ozone inlet and the other to the pump?

 

[griss]

No idea, but I’ll bump or you to see if someone else has any info.

 

[Los01]

Thanks!

 

[Grin Reefer]

I have the same skimmer but inject it straight into the ozone inlet port with CO2 scrubbed air powered by an air pump. If you're dead set on a recirculating system, you may be able to get a custom made CO2 scrubber cap made by Sam. See this link, Skimmer CO2 Scrubber Cap
You would have to see if Sam could modify the bottom of the cap to account for the top of the skimmer cup not being flat. Then just feed the outlet of the cap into the ozone port. (at least I believe this would work)
Also see this thread from that other site,

CO2 Scrubber with Tunze 9410

I have a Tunze 9410 skimmer. How can I run a co2 scrubber with this kind of skimmer?

www.reef2reef.com