How To connect power to 2 maxspec gyro with no controller but with icecap stuff

[winterpeg]

Hi ok This is what i bought

1. 2 xf250 no controller
2. 1 power supply
3. 2 icecap mods to hook up To apex
4. 2 icecap battery backups

Now I'm stumped to how to use 1 power supply and hook both of them up.

Any help would be great

Sent from my SM-G950W using Tapatalk

 

[Mark Bianco]

There is alot of unanswered questions here. Is the power supply you have for a XF250? If so then it will not be sufficient to power both pumps. If its some other type is it the correct voltage? 12 , 24, ect, AC, DC? Is the power supply rated high enough wattage to handle the load of two XF250's Too many varribles IMO to give an accurate reply.

Mark

 

[winterpeg]

Yep it's the power supply for the 250

You can buy them...

So then why can you use 1 power supply with there controller and run 2 xf250s as per the document.



Sent from my SM-G950W using Tapatalk

 

[winterpeg]

There is alot of unanswered questions here. Is the power supply you have for a XF250? If so then it will not be sufficient to power both pumps. If its some other type is it the correct voltage? 12 , 24, ect, AC, DC? Is the power supply rated high enough wattage to handle the load of two XF250's Too many varribles IMO to give an accurate reply.

Mark

Well I'm wrong.

I talked to maxspec and I need 2 power bricks when connecting to the icecap. This is due to the fact the controller has some power thingy that allows you to connect 2 with one power brick.



Sent from my SM-G950W using Tapatalk