How to program skimmer and main return on Apex Lite?

[Mr James]

I have tried to firgure it out by reading, but to no avail. Whatcommand do I use for the skimmer and the main return pump? Also, will both commands allow for a re-start delay??

 

[Deleted member 143833]

I assume you want them both on all the time???

Fallback On
Set On


If you want to turn them off for feed cycles or something else that also is possible.

Take a look at my program; it's online on my website; it might give you some ideas.

 

[Mr James]

Regarding the programs, which (I may slaughter this term because I am at work and shooting from memory)...which catagory do I put the skimmer and pump into?? I have the skimmer under "advanced" and the main pump under "pumps". Is this correct?

I looked at yours but may have a few questions about things, maybe I can ask you about, which would you prefer, a PM, post or E-mail?

 

[aquamanic]

Those programming modes are just there to help you with basic setup of the various types of devices. If you want your pumps on all the time, use the code that Ken posted and enter it via the 'advanced' mode. You can always add/change the code later as your needs change.

You can also get examples from the Handbook - see my sig.