tmccaffery
Member
I bought a used Profilux 4 and trying to remove everything and have factory default. It has in system extra powerbars; vortech controller etc and I dont have that. Is there away to clean everything out?
How to remove modules, etc?
- Thread starter tmccaffery
- Start date
If you haven't already, download https://www.aquariumcomputer.com/software/ghl-control-center/ and install GHL's GHL Control Center (GCC)
This only runs on a PC, so if you have a MAC, you will need to run Boot Camp, Parallels, etc.
Connect your P4 via the USB cable. Under the system tab, you can delete the modules you don't have. I would suggest deleting them all.
Then up top, open the Devices tab, there you can reset defaults, and update the firmware.
Hellsangelbx
New member
Did you figure it out and does everything work?
tmccaffery
Member
Yes figured it out. However, my conductivity probe cant get calibrated. I dont think its a big deal but maybe I need new probe.
Similar threads
