Safir
New member
I'm getting tired of lugging buckets to mix up water, So I built an over/under mixing station.
Top 55G drum = RO/DI
Bottom = Saltwater
there are valves to feed the pump from either salt or RO/DI barrels, and pump it either out to a hose (not pictured) or into the saltwater barrel to fill/mix it. Additionally, there is a drain at the bottom to drain one or both barrels without the pump, if needed.
There are unions so I can remove the pump or either barrel. and a Ball valve as well as a float valve on the RO/DI line.
I am looking for a few PVC/garden hose adapters to finish it up, and then put it in place of my current RO/DI holding barrel.
"Front" view
Plumbing Detail, the two tees with open sides are where valves and hose adapters need to go. Top right is pump output, bottom is "just in case" drain:
Top 55G drum = RO/DI
Bottom = Saltwater
there are valves to feed the pump from either salt or RO/DI barrels, and pump it either out to a hose (not pictured) or into the saltwater barrel to fill/mix it. Additionally, there is a drain at the bottom to drain one or both barrels without the pump, if needed.
There are unions so I can remove the pump or either barrel. and a Ball valve as well as a float valve on the RO/DI line.
I am looking for a few PVC/garden hose adapters to finish it up, and then put it in place of my current RO/DI holding barrel.
"Front" view
Plumbing Detail, the two tees with open sides are where valves and hose adapters need to go. Top right is pump output, bottom is "just in case" drain: