Is there a way to reset my 6095 without the controller?

[feel200]

I have a Tunze 6095 previously connected to a 7096 controller, and have done some wave settings to the pump. I have then since changed my tank size and have sold my 7096 before I realized I forgot to reset the setting in my 6095. Now I am only left with my 6095 and it only works according to my previous settings....

Now I wonder whether there is a way to reset my pump without the controller? Thanks tons!

:headwally:

 

[feel200]

Can anyone help? Thanks!

 

[rvitko]

The pump does not save any settings or have any memory. If you disconnect it from the controller it should simply run continuously. If the pump is cycling on and off with no controller, something is wrong with the pump, the most common issue being that it is partially jammed and is overheating, remove the propeller assembly, soak the pump and removed propeller/magnet in vinegar and water 50/50 to remove and calcium build up. There are other possibilities, including a dying motor or water damage to the end connector but calcium build up causing and overheat/overload in the most common.

 

[feel200]

Thankyou... will try to clean it tonight and hopefully it is not a pump issue...