Jebao WP60
- Thread starter likmonster
- Start date
tdb320reef
Active member
I bought two tested and then decided to stick with my MP60's. The flow is too narrow IMO. if you have the means to modify and open up the mouth Id image you would get the desired flow.
ebacon
Active member
ebacon
Active member
Agreed, as I said before they have great straight on flow, but for over all tank water circulation I like the vortec.
nuxx
.Registered Member
http://www.reefcentral.com/forums/showthread.php?t=2360126
BE VERY VERY VERY careful with these magnets though. They are no joke.
I have 6 on my 1" acrylic tank. 2 holding WP60s and 4 holding WP40s.
I actually covered all sides on the magnets that aren't against the acrylic with black duct tape and bubble wrap to make them a bit safer. Then covered the side against the acrylic with one layer of black duct tape.
If you order multiple magnets, ask they are wrapped / shipped individually. Trying to get them off of each other in a block separated by spacers (normal way of shipping multiples) is just dangerous to people not familiar with these kinds of magnets (me). I broke one trying to get them off and shipped the back to be sent back to me separated.
Hello couple questions,...why did you cover the sides not against the acrylic? And why the dt on the side against the acrylic? My tunze barely hold on my 1" acrylic, but I still need to slide them to separate the two. I don't think I would be able to do any sliding with duct tape on them.---Rick
nuxx
.Registered Member
The non-sticky side is against the acrylic, just didn't want the bare magnet against the acrylic.
Those magnets are so strong, I didn't want any metal object near the tank to fly at the magnet.
Not joking on how strong they are...
nuxx
.Registered Member
Thanks,...I was thinking maybe that was your reasoning, but had to ask.
No problem, I handle them like radioactive waste...
After my wife had one fly out of her hand and hit the stand I took a lot more caution with them ;-)
So I'm thinking on jumping onto two of these bad boys! I see that they now have a dual controller but none in the US, therefore shipping is $55. YIKES
Does anyone have the dual controller from fishstreet? is it worth the extra dough to get it shipped?
This is what i'm referring to: http://www.fish-street.com/jebao_twins_linkage_controller?category_id=35
any info is appreciated!
Does anyone have the dual controller from fishstreet? is it worth the extra dough to get it shipped?
This is what i'm referring to: http://www.fish-street.com/jebao_twins_linkage_controller?category_id=35
any info is appreciated!
I've been waiting on the dual controller from the NJ warehouse also. I even emailed them to ask when. They said not in the near future. But also told me if you do the math,...you can get 2 60's from NJ + shipping and need to get just the controller from China + shipping, all adds up to the same cost as buying the whole package from China. They have it all figured out. :lmao:---Rick
